MiLAN MIL-W2332G Guide de l'utilisateur télécharger pdf (Page 37)

3.3.3.3 Upgrading Firmware by TFTP

Fig. 26. TFTP server settings.

When use TFTP as the firmware management protocol, you can configure settings for

the AP’s TFTP client to communicate with a TFTP server. If the TFTP client does not

get a response from the TFTP server within a period specified by the Timeout setting, it

will resend the previous request. The Max number of retries setting specifies the

maximal number of resend before the TFTP client stops communicating with the TFTP

server.

Within the folder “Utilities” on the companion CD-ROM disk, we offered a TFTP server

program (TftpSrvr.exe) for firmware upgrade. Run this program on the computer that is

to serve as a TFTP server.

Fig. 27. Firmware upgrade by TFTP.

To upgrade firmware of the AP by TFTP:

1. Get a computer that will be used as a TFTP server and as a managing computer to

trigger the upgrade process.

2. Connect the computer and one of the LAN Ethernet switch port with a normal

Ethernet cable.

3. Configure IP address of the computer so that the AP and the computer are in the

same IP subnet.

4. On the computer, run the TFTP Server utility. And specify the folder in which the

firmware files reside.

5. On the computer, run a Web browser and click the General, Firmware Tools hy-

perlink.

6. Choose TFTP as the Firmware management protocol.

7. Specify the IP address of the computer, which acts as a TFTP server. If you don’t

know the IP address of the computer, open a Command Prompt, and type IpConfig,

then press the Enter key.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 69 70

Pas de commentaire

MiLAN MIL-W2332G Guide de l'utilisateur Page 37